8111
General Mach Discussion / Re: Is anyone else using E1P1 / E1P0 to switch output #1 ?
« on: July 05, 2010, 12:22:30 PM »
Hey Guys,
Just as a by the way thing....... If the command E1P0 is changed to E1P0M5 then the code runs perfectly every time on the few examples I have tested - But the turn off delay is increased again almost up to the levels of the M10P1.
Don't suppose this helps but thought I would mention it.
Tweakie.
Just as a by the way thing....... If the command E1P0 is changed to E1P0M5 then the code runs perfectly every time on the few examples I have tested - But the turn off delay is increased again almost up to the levels of the M10P1.
Don't suppose this helps but thought I would mention it.
Tweakie.