0 Members and 1 Guest are viewing this topic.
When I put the reading pins to pin 2 & 3 and I try to jog the voltage reading jumps from 5.18 to 5.17-5.16
Once you have that sorted set up pins 2 and 3 for the x axis motor. Put your meter leads between pins 3 and the one to the left of it 5V/G and see if you get a reading. Try jogging the x axis in both directions with your meter in place. You should see your reading change when you change directions. Look at your x axis dros in machs run screen and see if it counts up and down as you jog in different directions (right and left arrow keys jog the x axis).Brett
How do I check if I did not connect the motor cables incorrectly?