Machsupport Forum

G-Code, CAD, and CAM => G-Code, CAD, and CAM discussions => Topic started by: ttharp on January 02, 2014, 11:35:10 AM

Title: new to aspire and mach3 gcode help
Post by: ttharp on January 02, 2014, 11:35:10 AM

I have recently built a diy cnc and have successfully run gcode from others on the internet.  I have also written some myself and used some of mach's wizards to create some.  All with very good success.
Machine and mach appear to be set up correctly.  I recently purchased aspire and am attempting to create gcode from vector images.  I can create the tool paths and everything looks good in the preview model. I export the gcode and load and run it on my cnc and it stops before the project is finished.  I have done this with 2 different projects and i can't figure out why it's stopping.

if someone wouldn't mind looking over my attached code for errors i would appreciate it.

Thanks,
Travis

Title: Re: new to aspire and mach3 gcode help
Post by: ger21 on January 02, 2014, 11:54:17 AM

You need a licensed version of Mach3 to cut more than 500 lines of g-code.

Title: Re: new to aspire and mach3 gcode help
Post by: ttharp on January 02, 2014, 12:17:18 PM

my copy of mach should be licensed

i will double check to make sure there is not some type of registration error

Title: Re: new to aspire and mach3 gcode help
Post by: ger21 on January 02, 2014, 12:53:42 PM

Your name should be in the title bar, or in Help > About Mach3.

Title: new to aspire and mach3 gcode help
Post by: ttharp on January 07, 2014, 12:40:36 AM

Ok. Thanks.  This fixed it.  I thought I had registered the copy but I had not.   Sorry to have you answer this question for probably the thousandth time. 



Sent from my iPhone using Tapatalk (http://tapatalk.com/m?id=1)