I have an EMCOTurn140 running mach3. Everything was working fine, except for threading. While trying to sort that out, I discovered that many improvements have been made in threading in subsequent versions of Mach. Of course that was the first thing I thought to try.
I saved my .XML file, macros etc, and ran the installer. When I got Mach up and running again, I noticed a few issues.
The Home X and Home Y button no longer work....strange.
I found that I can use the set X home set Y home buttons to accomplish the same thing, weird, but I can deal with it.
The real problem is my tool change macro no longer works. I get the dreaded Cypress Enable internal error message. The macro is in the correct folder and executes partially. I know it gets to the go home command. The message I get says internal error on line 164. This is the beginning of a for next loop. None of the commands between the go home command and line 164 execute. This macro used to work flawlessly.
Anybody have an idea where I should look to resolve this issue?