I finally got my m6 macro working and have put together a short program to test my tool heights and offsets.
When I first ran the program, I had to stop a few times to make adjustments to heights and other things.
The program runs through 5 tool changes, and moves around a foam block. Just to check that the offsets are staying the same and consistant through different tools and heights.
The first couple times I ran it, it was a slow process of getting through the first couple changes trying to adjust the offset for my tool heights.
I got to where I was making it through three or four changes successfuly.
All of the sudden, out of nowhere, upon exiting the third tool change the program stops on the m3.
I have tried everything I could think of. re-writing and re-ordering the gcodes and layout with no success.
I can place different lines in front of the m3, such as spindle speed or ytoo offset. The RPM's and offsets may work but it will stop on the m3, even if it's in the same line.
All the gcode is a copy and paste, one after the other, with only changing the tool numbers. Minus the beginning and end.
I just cannot understand why it would be working just fine and then just stop working.
There is no errors or comunication in the history or error bar. It just stops and will not continue.
Has anyone dealt with or seen this before? Maybe have some ideas for me to try?
I would greatly appreciate some feedback.
I will attach the program as well.
Thanks in advance