1
General Mach Discussion / Zero Radius Arc
« on: December 14, 2014, 03:37:35 PM »
I would appreciate some input on a "Zero Radius Arc" message I'm getting. I've searched to the ends of the Internet and had no luck. The error is cutting dogbone fillets out of a part. I'm using a 1/8 endmill and the fillet's at .125" As suggested by other posts I drew a .125" diameter circle at the problem area representing the tool and it fit in and out of the fillet correctly. The code as G91.1 a the beginning as other posts have indicated.
I seem to get the error anywhere where I see I0.0000J0.0001 as part of the line. The first error I get on the following Gcode is line 3540.
G-Code link - https://www.dropbox.com/s/nr18osxm5hqwfji/f15new.txt?dl=0
Thanks for any help,
Mike
I seem to get the error anywhere where I see I0.0000J0.0001 as part of the line. The first error I get on the following Gcode is line 3540.
G-Code link - https://www.dropbox.com/s/nr18osxm5hqwfji/f15new.txt?dl=0
Thanks for any help,
Mike