2041
General Mach Discussion / Re: What Have I done?
« on: November 05, 2006, 05:27:23 PM »I am getting an Abnormal flashing button with a comment about "Axis are not refed to normal condition". Somehow I started this and now can't figure out how to correct the problem. OK, I am not sure what it means or what I did to cause it.
Can anyone help?
Jim
If this is still the problem... all you need to do is set up your machine so that it is ready to run and double click on the "Normal Condition" and it will set that state to be the normal run condition of your machine that is all it is..