1891
German / Re: Hilfe bei der Laser Einrichtung
« on: August 13, 2018, 05:16:17 AM »
Hi Matthias,
I am using a CO2 laser which will cut into the acrylic if the power level is set too high.
This test was done the same way as the previous example, using air-assist and two passes. I don't think the small letter size should be a problem.
Tweakie.
I am using a CO2 laser which will cut into the acrylic if the power level is set too high.
This test was done the same way as the previous example, using air-assist and two passes. I don't think the small letter size should be a problem.
Tweakie.