Messages

1891

General Mach Discussion / Re: Only X-axis motor is working

« on: March 22, 2018, 03:59:10 AM »

cheap or expensive does not matter for the Moment.
without a propper XML None of them has a Chance to work.

1892

General Mach Discussion / Re: Only X-axis motor is working

« on: March 22, 2018, 02:37:42 AM »

ok had a look to your XML.
it seems to be bad, it contains only Step per, ACC and Vel infomation for axis 0 (x).
i know that Information is shown for the other axis in Motor Tuning, dont ask me why.

so i would start with a new fresh Profile, Setup axis should not take very Long.

1893

General Mach Discussion / Re: Only X-axis motor is working

« on: March 21, 2018, 03:34:03 AM »

You were correct. I had the power supply on the wrong side. I feel so dumb.

Hooked it up correctly and the weird thing is nothing changed.

X still works. The other three axis do not work.

So, did I burn out two boards with them being hooked up backwards? And why would this stupid thing work with the X-axis no matter how it's hooked up? I know this is stepping outside of the Mach3 software questions at this point and do appreciate the help I've received.

so have you tried to swap X an Y Step/Dir Connection on your breakout board ?

have you configured enable pin14 now ?

can you please post your XML ?

your axis dro's are changing on Screen if you move the other axis ?

1894

General Mach Discussion / Re: Only X-axis motor is working

« on: March 20, 2018, 03:56:22 PM »

insight -> 100 points

1895

VB and the development of wizards / Re: 2 scripts 1 button

« on: March 20, 2018, 11:59:04 AM »

create a Folder C:\mach3\test
copy a couple of files there
Change the path in the macro
test again

1896

General Mach Discussion / Re: Random jolts?

« on: March 20, 2018, 11:55:50 AM »

or some other Software on the pc, witch frezes all

1897

General Mach Discussion / Re: Only X-axis motor is working

« on: March 20, 2018, 11:54:38 AM »

ok, i have rotated my pic, and put both underneath,
just to avoid optical Illusion.

and now i am out of ideas to Point you to the fault

1898

VB and the development of wizards / Re: 2 scripts 1 button

« on: March 20, 2018, 08:51:38 AM »

Looks like i has something to do with your file attributes (see Picture)

can cou cross check with gcode lavori files ?

1899

VB and the development of wizards / Re: 2 scripts 1 button

« on: March 20, 2018, 08:02:11 AM »

---the jobs \ gcode section works well

you mean "GCODE LAVORI" ?

are you sure the files are in C:\mach3\gcode ?

because here it works

1900

VB and the development of wizards / Re: 2 scripts 1 button

« on: March 20, 2018, 07:22:31 AM »

for the Moment i do not understand what you mean,
the script loads here any GCode file in c:\Mach3\GCode