Messages

3481

General Mach Discussion / Re: Encoder as feed rate override?

« on: February 23, 2006, 07:12:02 PM »

I don't think so

3482

General Mach Discussion / Re: Missing Steps or is it something else? Help!

« on: February 23, 2006, 05:50:36 AM »

I think it that driver just needs a long step pulse... Can't tell from there Doc's

3483

General Mach Discussion / Re: Encoder as feed rate override?

« on: February 23, 2006, 05:48:07 AM »

no but you can use a pot with modio or a PLC...
Hope that helps
Brian

3484

General Mach Discussion / Re: Missing Steps or is it something else? Help!

« on: February 22, 2006, 04:52:58 PM »

What do you have for drives?

3485

General Mach Discussion / Re: Missing Steps or is it something else? Help!

« on: February 22, 2006, 02:52:08 PM »

I think it would

3486

General Mach Discussion / Re: Missing Steps or is it something else? Help!

« on: February 22, 2006, 06:47:54 AM »

what is your step width (on the motor tune page)? try it set to 5 us and back down the  accel. If that is a no go we can try to changing you to sherline mode to give you a nice long pulse for the drive.

Hope that is some help
Brian

3487

Newfangled Solutions Mach3 Wizards / Re: NFS Addins for Mach3Mill Questions

« on: February 21, 2006, 07:56:00 PM »

1.84 is the release and Yes the NFS wizards are in the install (If you didn't uncheck them on install)

Hope that is a help
Brian

3488

General Mach Discussion / Re: Shift Key

« on: February 20, 2006, 11:34:31 PM »

okay I will have a look tomorrow

3489

General Mach Discussion / Re: Shift Key

« on: February 20, 2006, 11:11:12 AM »

You give me the scrren set that you are going to be running and I will add in the code

3490

Newfangled Solutions Mach3 Wizards / Re: DMM Wizzard?

« on: February 20, 2006, 06:37:16 AM »

Please load this set and test it OVER the part by triggering the probe with a stick or something. This will give you the Arccenter with the press of a button:)

Benny and I willl make MUCH better one but that wil come in due time.