Messages

1481

General Mach Discussion / Re: XY Arc Problems which Crash Machine still cropping up

« on: March 12, 2007, 11:38:22 PM »

If you would like to have the problem looked at you will have to make the file 5 lines long with the problem line in the middle of the file. The long files take about 30min to pare down and Art and I don't have the time to do that at this point

Thank you and hope we can get this fixed for you
Brian

1482

General Mach Discussion / Re: XML file - strange happenings

« on: March 12, 2007, 11:33:38 PM »

Post your XML and I will see if I can get that to happen to me... that is odd..

1483

General Mach Discussion / Re: Cannot get homing and limits to work

« on: March 12, 2007, 11:31:52 PM »

Have you set a denounce? Sounds like you need to have about 1500 to start with

1484

General Mach Discussion / Re: eratic g01/g02/g03

« on: March 07, 2007, 06:34:42 PM »

Open MSconfig and uncheck all the programs that would like to load at Startup.

1485

Show"N"Tell ( What you have made with your CNC machine.) / Re: New to the Forum

« on: March 07, 2007, 06:28:46 PM »

Some people get to have all the fun!

I have not run a machine in a long time to make anything test test test that is all I get to do...

Thank you for posting!

1486

Show"N"Tell ( What you have made with your CNC machine.) / Re: New to the Forum

« on: March 07, 2007, 07:59:39 AM »

Good looking work! What are you building?

1487

General Mach Discussion / Re: Boss 9 retrofit querry

« on: March 07, 2007, 07:56:33 AM »

The problem is that you are running to high a resolution encoders for the G340's You would be better off with 500 line because that would allow for more following error (they only have +/-128 encoder counts). With the encoders that you have that is a VERY small amount! You could change the encoders or you could use the other servo amps. I have a guy that works with me that will be selling the Tek drives here in the states and could help you if you would like. (Send me a MP and I will get you his info). I am software and NOT hardware so i am not the one to talk to

Thanks
Brian

1488

General Mach Discussion / Re: run from here problem

« on: March 07, 2007, 07:50:19 AM »

Use Set next line and have a safe startup block

Run From here and Subs don't play nice

1489

General Mach Discussion / Re: Some problems with Mach 3

« on: March 07, 2007, 07:46:14 AM »

No problem, you did one that I had not seen in the past and now I know what happens to a machine if MaxNC mode is on...  I learn more everyday!

1490

Third party software and hardware support forums. / Re: ProfiBus, controlnet or devicenet support ?

« on: March 07, 2007, 07:44:09 AM »

That will make the comuter talk on the network but Mach3 will not send the movment data over the Comport becasue there is not a plugin for that at this time I have a plugin started that will send the movment data over the comport but just have not had the extra time needed to work on it.

Thank you and looks like they will work once the plugin is done