2461
Mach4 General Discussion / Re: Mach4 Huanyang GT series Modbus setup
« on: May 27, 2019, 09:47:43 AM »
Hi,
if you have a look at the code behind the DRO in the screen editor I think you'll find its called 'TrueSpeedDRO'.
Mach displays the spindles true speed by timing the index pulses doing the required calculation and displaying the result.
If you do not have a index signal generator attached to the spindle the DRO will not display anything.
Craig
if you have a look at the code behind the DRO in the screen editor I think you'll find its called 'TrueSpeedDRO'.
Mach displays the spindles true speed by timing the index pulses doing the required calculation and displaying the result.
If you do not have a index signal generator attached to the spindle the DRO will not display anything.
Craig