1
General Mach Discussion / Possible configuration problem on new Mach3 installation
« on: March 03, 2020, 02:55:04 PM »
The computer which we had running Mach3 died and we had to set everything back up on a new PC. We had to get a parallel port to USB adapter for the new PC. Software is installed, license file is installed, driver for the new adapter is installed and all seems to be working. Device Manager detects the machine, the driver, and is showing no errors.
However, when anything is attempted Mach3 either nothing happens or we get this error: Cannot do g1 with zero feed rate, Block=G01Y-1234.75
Is that pretty solidly identifiable as a configuration problem or is there a possibility I'm having driver issues?
I am actually someone from the IT department and I do not operate this machine and have limited understanding of how it actually works beyond the initial software setup.
However, when anything is attempted Mach3 either nothing happens or we get this error: Cannot do g1 with zero feed rate, Block=G01Y-1234.75
Is that pretty solidly identifiable as a configuration problem or is there a possibility I'm having driver issues?
I am actually someone from the IT department and I do not operate this machine and have limited understanding of how it actually works beyond the initial software setup.