Messages

3711

General Mach Discussion / Re: Ignore Tool Change

« on: December 09, 2005, 02:09:39 PM »

All the settings are in the XML file and the tool table is in the Mach3\macros\Mach3Mill\tools3 file

when I do this I like to save all the macro's too


Hope that helps
Brian

3712

General Mach Discussion / Re: Ignore Tool Change

« on: December 09, 2005, 01:54:09 PM »

I think you my have to reinstall Mach3. I tested your XML here and it looked great! I have seen this problem 

Thank you and sorry the XML didn't do it
Brian

3713

General Mach Discussion / Re: Multi Pass Wizard

« on: December 09, 2005, 01:43:42 PM »

Mach3 is what is stopping the multi pass from working Not me If you are not in DEMO mode in Mach3 it should work great for that file... (it did here).

Hope that helps
Brian

3714

General Mach Discussion / Re: Ignore Tool Change

« on: December 09, 2005, 01:07:48 PM »

The XML is in the Mach3 directory and is going to be named Mach3Mill .xml if you are using mill. If you are using a lathe it will the the turn XML

You can send it to me a brianb@newfangledsolutions.com


Thanks
Brian

3715

General Mach Discussion / Re: Multi Pass Wizard

« on: December 09, 2005, 12:58:32 PM »

This file is very close to 1000 lines 1000 lines is the Max amount that you can run in the DEMO mode. If you try  smaller file it should work great.


Hope that helps
Brian

3716

General Mach Discussion / Re: Ignore Tool Change

« on: December 09, 2005, 12:53:33 PM »

Could you send me your XML file and I will have a look at it. I have tested it here and it is working as it should... I am tinking you may have a bad XML.

Thank you
Brian

3717

General Mach Discussion / Re: Ignore Tool Change

« on: December 09, 2005, 09:26:00 AM »

please change the setting and exit Mach3. When you exit Mach 3 it should save the setting. The Exit needs to be done by closing the software not by powering down the computer.

Hope that helps
Brian

3718

General Mach Discussion / Multi Pass Wizard

« on: December 09, 2005, 08:14:52 AM »

There is a new video for multi pass to help you learn to use it. I you would like to comment on the wizard and or ask for changes in how the wizard functions.
Here is the link to the video:
http://www.machsupport.com/MultiPass/multipass.html

Thank you for your input
Brian

3719

General Mach Discussion / Re: Excelon file converter

« on: December 06, 2005, 08:34:19 PM »

I am going to work on it as soon as I make a few more support video's... I just got a new computer and I have been setting it up... I need to put C++ on and get started, But the converter seems to work now:)

The Wife is out this weekend so I will have all the time I need

Brian ( I need to stop going to work, it is getting in on my fun... )

3720

General Mach Discussion / Re: where is the motor reversal box

« on: December 06, 2005, 08:28:31 PM »

The other way to change this is under the ports and pins Active Low setting for the Dir pin on that axis...

Hope that helps
Brian