Messages

2691

General Mach Discussion / Re: Rapid Travel

« on: June 27, 2006, 07:17:07 PM »

Press the Tab key and set your slow jog rate to 100% If the motors are not happy go to the motor tuning and turn down the Velocity of the motors.

2692

General Mach Discussion / Re: External Feedrate adjustment

« on: June 27, 2006, 07:13:47 PM »

This can be done but a plugin would need to be written...

2693

LazyCam (Beta) / Re: lazycam

« on: June 26, 2006, 11:53:11 PM »

It is about time I have been adding code for an OEM so there were many changes in LCAM.... I was working all the bugs out and now it is time to start back on the offset path  That is not as much fun as I had hoped it would be  I have all the line to line code done! so LCAM can take a path that is all lines and offset the path and trim all the lines to the right length... This is all so the first part to get pocketing done... I need more TIME!!!!

Thank you (Just wanted to tell you what I was working on next)

2694

General Mach Discussion / Re: digitizing

« on: June 26, 2006, 11:46:34 PM »

I don't know Rhino but you are loading a point cloud

2695

General Mach Discussion / Re: 50 in/min but no faster

« on: June 26, 2006, 11:45:16 PM »

You should be able to take up the velocity with the Accel down...
Hope that helps
Brian

2696

General Mach Discussion / Re: Question regarding solid shapes!!

« on: June 26, 2006, 07:33:14 PM »

Are you talking about teaching the machine the position? If so there is the teach wizard but it will not do points at this time

If you would like to do it with AutoCad you can save it as a 2D file and all points will be drilled

2697

LazyCam (Beta) / Re: lazycam

« on: June 26, 2006, 07:30:33 PM »

The file runs here... Could you check to see that you are not in inverse time mode (G93) ? You should be in G94 UPM mode

2698

General Mach Discussion / Re: Question regarding solid shapes!!

« on: June 26, 2006, 07:14:53 PM »

You will need Cam software to read the 3D solids   LazyCAM will only take in a 2d file.... Google "Cam CNC" That should get you started

2699

VB and the development of wizards / Re: External program called from VB Script

« on: June 26, 2006, 07:10:03 PM »

Is this in a text file? or are you reading it from a program that is running?

2700

General Mach Discussion / Re: which Breakout Board

« on: June 26, 2006, 10:50:15 AM »

I think we are seeing not so good drives