Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: billpardee70@gmail.com on July 26, 2020, 09:13:25 PM
-
Every time I set my Z height, when I hit start , it goes straight down and plunges into the wood. I have to zero my Z height two or three times to get it to work right. I am tired of wasting wood.
I am using Mach 4 Hobby
PMDX controller
Thanks,
Bill Pardee
-
Check your tool offsets, if you are only using 1 tool then you do not need a height value in the offset for that tool.
-
Check your tool offsets, if you are only using 1 tool then you do not need a height value in the offset for that tool.
And once that's done, read the gcode and see where it's telling the machine to go.