2201
General Mach Discussion / Re: LOST BUT NOT BEATEN
« on: February 19, 2018, 01:39:15 AM »
Hi Forbri40,
I have sent you a PM.
Tweakie.
I have sent you a PM.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Do you have suggestions which manufacturer to looking for? I have Yako MS-L Servo drives for Y axis -> http://www.yankong.com/EN/index.php/proview-60-26.html At the moment I am not at work to give models of other devices but I can give more info if needed.
One more question - is it possible to change strength of motors so CNC turns off in case some cutted parts move away from their original position (small parts) and goes between something? I know to use tabs, but I cut plywood and it is not so stable to have good tab all the time. And too strong tabs cause too much time to remove or may damage surface of playwoon when removing.
At the moment motors needed to apply too much power to make losing steps and even when it happens it mostly turns off only one motor and all other motors continues their job which is bad.
Wouldn't it be cool if along with laser cutting, it also had a sensor that gauged depth at the same time!
My problems now I think are mainly the damn theta lens, one of those things with very little information to go on.