16062
« on: March 25, 2010, 11:53:17 AM »
You can only use them as Limits for one end of the axis, ie either X++ OR X-- depending on which end they are at. Unless that is the switch is in the middle and the trigger is either end.
That however should not be your problem as it would just mean they wouldnt activate properly if set up as both X++ AND X--.
When you enable them do you see the LED on the diagnostics page light?
Softlimits should be easy, X min Y min and Z Max will be zero, X Max, Y Max will be your travel and Z Min will be your travel but a negative value. If your home switches are at the wrong end of the table from machine coords zero then you also need to enter a Home Off value equal to the distance of the travel.
Hood