Messages

541

PoKeys / Re: z axis

« on: May 19, 2009, 11:10:00 AM »

Boris,
I am using a joystick for the x and y. I want to use a spring return pot for the z axis.
Bill

542

PoKeys / Re: z axis

« on: May 19, 2009, 10:36:52 AM »

Boris,
Analog input only gives the choices of X, Y , RotX, RotY and Throttle. No Z axis.
Bill

543

PoKeys / z axis

« on: May 19, 2009, 10:01:25 AM »

How do I set up PoKeys to use an analog input for the Z axis?
Bill

544

General Mach Discussion / Re: button code

« on: April 30, 2009, 12:20:17 PM »

I think I did make and use a transparent png for the button but I will check.
Thanks everyone,
Bill

545

General Mach Discussion / button code

« on: April 28, 2009, 09:00:07 AM »

I have the following code in a button.
There are 4 buttons and I only want the one clicked on to have the led turned on.
Each button has 2 leds.
One is around the button and changes color and the other is a fake button that sits over a transparent button.
The led that is around the button always works.
The led that is a fake button usually does not change.
What am I doing wrong?

If (GetUserLED (1141) = 1) Then
SetUserLED (1141, 0)
Else
If (GetUserLED (1142) = 1) Then
SetUserLED (1142, 0)
Else
If (GetUserLED (1143) = 1) Then
SetUserLED (1143, 0)
End If 
End If
End If 
SetUserLED (1140 , 1)

Bill

546

General Mach Discussion / Re: init.m1s

« on: March 30, 2009, 10:50:47 AM »

Tweakie,
If it was me running the machine no problem. I have to make this as easy as possible for the operator. The less they have to do the less likely something will get forgotten or not done.
Bill

547

General Mach Discussion / Re: init.m1s

« on: March 30, 2009, 10:48:18 AM »

Scott,
Thanks again. Just what I needed.
Bill

548

General Mach Discussion / init.m1s

« on: March 30, 2009, 08:59:44 AM »

If I make a macro called "init.m1s", to ensure leds are turned off, does it run only when mach starts?
Bill

549

General Mach Discussion / Re: How Much interest is there in an UPDATE to the Mach specific VB??

« on: March 27, 2009, 03:21:05 PM »

Scott,
Ignore me I can obviously not read. I see it in your list now.
Bill

550

General Mach Discussion / Re: How Much interest is there in an UPDATE to the Mach specific VB??

« on: March 27, 2009, 08:20:35 AM »

Scott,
One more send keys. If you need to send an enter.

Sendkeys "{Enter} , True"

We found this one when you were here to help with my tcp camera issue.
Bill