18651
General Mach Discussion / Re: Sequence to zero XYA--Z
« on: July 09, 2009, 02:02:48 AM »
You would need to make up a VB button if you wis to do the sequence differently as the GoToZ is coded into Mach.
Having said that maybe all you are needing to do is set a safe Z, if you do that setting the safe Z as machine coords 0 then what will happen when you GoToZ is the Z axis will rise fully up the X, Yand A will go to your offset zero then finally the Z will move down to your offset zero.
Hood
Having said that maybe all you are needing to do is set a safe Z, if you do that setting the safe Z as machine coords 0 then what will happen when you GoToZ is the Z axis will rise fully up the X, Yand A will go to your offset zero then finally the Z will move down to your offset zero.
Hood