Hi All,
Does anyone have an idea what this error means?
Used a PC (PC1) to set up Mach3 turn on my SC2 lathe and cut a thread to check all was working ok, and it was and still is for PC number 1. Copied the XML to another PC (PC2) and now on this one I get the following errors in the Last Errors file:
Mon - 16:11:10 --- Threading Calc: Vel (IPM): 178.7176 Actual Calc Pitch: 0.8000 Spindle: 223.3971
Mon - 16:11:10 --- Last Reported Thread run values.....
Mon - 16:11:10 ---Spindle Lock: 5424 , Total Ints: 0, Total Spindle Ints: 0, Error: 844, Adder: 0 LastRot: 6758
Mon - 16:11:10 ---Spindle Lock: 5424 , Total Ints: 5871, Total Spindle Ints: 5424, Error: 447, Adder: 0 LastRot: 6707
Mon - 16:11:10 ---Spindle Lock: 5424 , Total Ints: 12102, Total Spindle Ints: 10848, Error: 1254, Adder: 0 LastRot: 6674
Mon - 16:11:10 ---Spindle Lock: 5424 , Total Ints: 17555, Total Spindle Ints: 16272, Error: 1283, Adder: 0 LastRot: 6713
Mon - 16:11:10 ---Spindle Lock: 5424 , Total Ints: 23102, Total Spindle Ints: 21696, Error: 1406, Adder: 0 LastRot: 6856
Mon - 16:11:10 ---Spindle Lock: 0 , Total Ints: 0, Total Spindle Ints: 0, Error: 0, Adder: 0 LastRot: 0
Mon - 16:11:10 --- Threading Calc: Vel (IPM): 178.2317 Actual Calc Pitch: 0.8000 Spindle: 222.7896
Mon - 16:11:10 --- Last Reported Thread run values.....
Mon - 16:11:10 ---Spindle Lock: 0 , Total Ints: 0, Total Spindle Ints: 0, Error: 0, Adder: 0 LastRot: 0
Mon - 16:11:41 ---Too Slow for Pulley..Using Min.
Considering a bit further, the only difference between the two computers is the parallel address port, I imported my XML files for the preferences into a databse and found no differences.
I need to understand where this is coming from as it must be due to a PC clocking issue or something like that. Hoping that if the cause of the error can be established I can rule out thios PC complelety.
Hope you can help.
Paul