Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: james888 on March 31, 2024, 04:07:25 PM

Title: Homing Issues
Post by: james888 on March 31, 2024, 04:07:25 PM

I am having issues with my homing of my X axis ( slaved to A axis), Everything works fine when jogging, but when homing the X the slave motor (A) runs but the X does not. I have the motors slaved and tuned the same. Any help would be greatly appreciated.

Title: Re: Homing Issues
Post by: cncmagic on April 04, 2024, 09:23:14 PM

if you are using Mach4 you need to discuss with the mfg of the motion board.. Mach4 does not actually control the homing procedure the motion card does.  :o