2871
General Mach Discussion / Re: Mach3 / PMDX-122 Issue
« on: March 19, 2019, 10:55:38 PM »
Hi,
Ok, not familiar with that stepper drive but I see from the pic of your BoB you have four wires going to each drive,
two of which are Com and the other two presumably Step and Direction. I would have thought that you would need
at least two more wires, one for yet another Com and the remaining wire an Enable.
Do you have any documentation for the driver?
Craig
Ok, not familiar with that stepper drive but I see from the pic of your BoB you have four wires going to each drive,
two of which are Com and the other two presumably Step and Direction. I would have thought that you would need
at least two more wires, one for yet another Com and the remaining wire an Enable.
Do you have any documentation for the driver?
Craig