641
General Mach Discussion / Re: Which Control/Breakout Board
« on: July 04, 2016, 04:04:52 PM »
CSMIO/IP-M may be worth a look, differential Step/Dir , 12 Inputs, 4 outputs, 2 relay outputs, 2 analogue inputs and 2 analogue outputs.
Digital I/O is 24v for noise immunity and the analogue inputs can be used for pots for overrides and the analogue out can be used for spindle control so no need for extra spindle controller and no need for a breakout board.
Also it is Ethernet so a solid interface.
They are from Poland.
Hood
Digital I/O is 24v for noise immunity and the analogue inputs can be used for pots for overrides and the analogue out can be used for spindle control so no need for extra spindle controller and no need for a breakout board.
Also it is Ethernet so a solid interface.
They are from Poland.
Hood