4261
G-Code, CAD, and CAM discussions / Re: Please help a newbie with cad
« on: September 18, 2010, 05:43:42 AM »
Under Options in LT is it set to Diameter and Metric Mode is unchecked?
RICH
RICH
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
VectorEngineer Cad SoftwareJust took a quick look at the site and seems like it will do what you need, if purchased, since the free one dosn't save files as a dxf.
machined in its positionJust draw the profile with the center line of the face at X & Z =0. There are a few rules which are all covered in the LT manual along with other tips, see Appendix "B".