2921
General Mach Discussion / Re: Z home goes past 0.0 to +1.0
« on: January 29, 2012, 05:36:07 AM »Quote
Most just don't bother to read and study them.
Terry,
Maybe we should start a thread on the subject to explore it some. We live in a world of plug and play, but one must admit that it can be frustrating
when trying to grasp just one subject from what is documented.
An example relating to limit and home switches on documentation:
MANUAL PAGE
USING MACH3 MILL 4-8 to 4-11, 5.3,5-17,6-2, 12-1, 1-17
MACH3 CNC CONTROLLER SOFTWARE & INSTALLATION 4-9 to 4-15, 5-5, 5-6
MACH3 TUTORIAL (setting up a 3axis machine) 11,12,13,14
CALYPSO MANUAL 61
Lets not forget about getting off the limit switches ( USING MACH3 MILL page 4-10)
ttm,
Above is worth reading and studying to understand. What makes this more difficult is the use of a different screen set than normaly used
and requires additional attention and information to get to the problem. You can thank the folks in here for going the extra mile spending
their time to find what they need to address the problem.
Remember that all this is supposed to be fun,
RICH