Tweakie, Is it converting the gcode or my machine setup? So, when I want to work in inches, (my machine came from the factory in mm}, where and when do I change settings?
I was expecting to get a boxed license for Mach3 from the factory, but did not. They sent me a file ( NCUsb.Pod }, driver to install in Mach3 folder. I had already downloaded your demo version to practice on and loaded my factory parameters.
I have a Mach3 USB motion controller MKX-IV, and I'm running Windows 10 on a new HP All in One. After I make sure my machine works satisfactory, I'll order the license. I hope this is Kosher.