11821
General Mach Discussion / Re: Anilam 1100 encoders
« on: April 29, 2011, 09:58:47 AM »
If you will be using the parallel port you would be looking for an encoder of around 500 lines (2000 quadrature) There are many ways of fitting encoders but the ones entioned above are hollow shaft modular types and can be bought to suit the shaft size of your motor (up to a certain size depending on model of encoder)
Watch what you are doing when removing the armature from a motor as you can easilt damage the magnets as they have a very strong pull and can chip if you let them hit the outer casing. Also I believe that if left outside of the motor for extended periods you risk a certain amount of demagnetization.
Hood
Watch what you are doing when removing the armature from a motor as you can easilt damage the magnets as they have a very strong pull and can chip if you let them hit the outer casing. Also I believe that if left outside of the motor for extended periods you risk a certain amount of demagnetization.
Hood