Hi,
How is it, are these IOs protected e.g. against short circuit or not?
yes only step/dir not.
Are the signals fixed or can these be configured in Mach like it is the case with LPT-port?
in Mach3 port/pin -> motor outputs only the enable axis is important rest is done in the
configuration of the cs-lab plugin.
for the wiring, you first have to figure out, witch inputs your motor controllers have,
the choose the right wiring diagram.
just cannot get the meaning of "and in the CSMIO/IP-M we have to use the GND on 2nd PIN or ANALOG I/O 8 connector"
Where the GND can be found from, is it analog IO terminal pin #2 or pin#8 or what?
CSMIO/IP_S GND at step/dir connector pin 13
CSMIO/IP_M GND at analog connector pin 2 or pin 8
Regards Thomas
also not a native English speaking person