4321
General Mach Discussion / Re: I went to cut my first operation and ..... nothing..
« on: September 01, 2013, 04:56:01 PM »
As Jim has said it is G21 in code but it looks like dimensions are meant to be metric and thus the axis are hardly moving.
I was wanting to see your xml to see if your setup units were correct and for inch but if you try as Jim suggested and change the G21 to a G20 and see what happens, if not you can attach your xml by looking for the profile name when Mach is opened. You then go to the mach folder and look for a file of that name with a .xml file extension. Copy that to your desktop then rename to mrich0908.xml then use the additional options on the reply page to attach the renamed file.
Hood
I was wanting to see your xml to see if your setup units were correct and for inch but if you try as Jim suggested and change the G21 to a G20 and see what happens, if not you can attach your xml by looking for the profile name when Mach is opened. You then go to the mach folder and look for a file of that name with a .xml file extension. Copy that to your desktop then rename to mrich0908.xml then use the additional options on the reply page to attach the renamed file.
Hood