411
General Mach Discussion / Re: Soft Limits and a Linear A axis
« on: November 01, 2010, 10:54:06 AM »
No problem!
Thanks
Thanks
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Just tried in simulation here and softlimits work fine for A axis, are you sure you have the softlimits enabled and rthe correct values set on Homing and Limits page?
Should work fine I think, have you unchecked the A as Angular on General Config page?
Just as a side note, the closed loop spindle control does or doesn't work with SS? In your setup, if it does work, if you put a load on the motor, how long does it take Mach 3 to respond and bring the speed back up?