Hello Guest it is May 08, 2024, 12:39:14 AM
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
| Filename | Downloads | Message |
Posted
|
|---|---|---|---|
| 8.dxf | 385 | Re: LazyTurn | November 12, 2008, 09:08:20 PM |
| 8_DXF_HCIR_1.jpg | 779 | Re: LazyTurn | November 13, 2008, 08:00:15 PM |
| 9_HCIR.jpg | 754 | Re: LazyTurn | November 13, 2008, 08:21:31 PM |
| 8_DXF_HCIR_2.jpg | 786 | Re: LazyTurn | November 15, 2008, 05:28:40 PM |
| testtrue.jpg | 405 | Re: Lathe Screwcutting problem | November 16, 2008, 08:18:01 AM |
| indexhcir.JPG | 457 | Re: Spindle Speed measurement question | November 23, 2008, 07:08:31 PM |
| VMR_TRACER_PEN.jpg | 432 | Re: making parts to size on customer prints | November 26, 2008, 11:20:37 PM |
| VMR_GCODE_CHANGES.jpg | 422 | Re: making parts to size on customer prints | November 26, 2008, 11:20:37 PM |
| VMR_COMP_COMPARE.jpg | 437 | Re: making parts to size on customer prints | November 26, 2008, 11:20:37 PM |
| 1X2CON_G41_P1.txt | 215 | Re: making parts to size on customer prints | November 26, 2008, 11:20:37 PM |
Guest