2991
General Mach Discussion / Re: Can this computer run mach3
« on: February 20, 2017, 03:32:57 AM »
You can't use Port1 Pins 2, 4, 6 for Output Signals when they are already used for Motor Outputs.
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
As soon as the XLR connector (with the sield connected to it) is in contact with the metal case and therefore with the star ground, the Y axis gains steps.