Messages

1221

General Mach Discussion / Re: My stepcraft DL445 laser leaves a path

« on: June 13, 2019, 11:59:02 PM »

i will try to contact stepcraft to get more information

1222

Screen designer tips and tutorials / Re: LED not showing with transparency

« on: June 13, 2019, 02:09:08 PM »

or use a tranparent button

1223

General Mach Discussion / Re: My stepcraft DL445 laser leaves a path

« on: June 13, 2019, 02:03:59 PM »

well, walked through the stepcraft Manual, not getting 100% clever, but here a "try"

pls try also Output1 Active Low Setting.

1224

General Mach Discussion / Re: My stepcraft DL445 laser leaves a path

« on: June 13, 2019, 12:51:35 PM »

sorry missed that you posted your Profile.

you are Controlling your laser via Spindle Motor control step Signal (chankspindle/chankspindleoutput).

output1 is assigned to pin0 (chankoutputs), so M10P1/M11P1 can not work (should be pin17)

1225

General Mach Discussion / Re: My stepcraft DL445 laser leaves a path

« on: June 13, 2019, 12:36:52 PM »

never used it, but M10P1 means Switch Output 1 ON, and to what (ports&pins) is your Output#1 assigned.

for the Moment you use M3/M5 to turn laser ON/OFF?

what is your output configuration Config -> Ports&Pins -> Spindle Setup -> Relay Control ?

are you using are original UC100 or a chinese clone?

1226

General Mach Discussion / Re: too slow for pulley using min

« on: June 13, 2019, 12:21:21 PM »

for radius Problem goto Config -> General Config and make Setting correspondig to post processor

1227

General Mach Discussion / Re: too slow for pulley using min

« on: June 13, 2019, 12:18:39 PM »

goto Settings and check witch pulley is selected

goto Config -> Spindle Pulleys and check Min value of selected pulley

1228

General Mach Discussion / Re: My stepcraft DL445 laser leaves a path

« on: June 13, 2019, 12:12:34 PM »

had a quick look to the UC100 manual Appendix A. : New functions and bug fixes:
it should Support M10/M11.

but don't know wether it is working

1229

General Mach Discussion / Re: Motors stalling /growling

« on: June 10, 2019, 03:42:42 AM »

ok that means microstepping and steps per are correct.
next step would be to have a look with oszilloscope for the step/dir signals.

1230

General Mach Discussion / Re: Motors stalling /growling

« on: June 09, 2019, 06:35:41 AM »

When entering the G1 xo.1968 f1, it keeps turning never stops and is very slow and rough sounding.

have you zeroed x-axis before Input?