7391
General Mach Discussion / Re: Help! Vibrating motors and hotwire!!
« on: March 05, 2011, 03:10:39 AM »
Blake,
It could be a resolution issue with the software you are using (a curves created with 6 straight lines is a bit jerky compared with the same curve created with 60 straight lines) perhaps not set up correctly ?
Try another software to generate some code and see if you get the same results.
Tweakie.
It could be a resolution issue with the software you are using (a curves created with 6 straight lines is a bit jerky compared with the same curve created with 60 straight lines) perhaps not set up correctly ?
Try another software to generate some code and see if you get the same results.
Tweakie.