1
General Mach Discussion / Re: Pulse width help
« on: April 08, 2013, 10:40:26 AM »
Hello again and thanks for your thoughts! I thought I would do a follow up to my question in case anyone else had this problem.
I checked all wiring connections at the recommendation of this thread and that proved not at fault. I then removed the Cmos battery from the computer and that caused all the settings in Bios to reset to factory. That did the trick and the machine is acting normal again. If your axis is reversing by itself this may help you fix the problem. Steve
I checked all wiring connections at the recommendation of this thread and that proved not at fault. I then removed the Cmos battery from the computer and that caused all the settings in Bios to reset to factory. That did the trick and the machine is acting normal again. If your axis is reversing by itself this may help you fix the problem. Steve