7171
Mach4 General Discussion / Re: Mach 4 Machtric 2.2kw VFD Modbus
« on: January 28, 2017, 05:27:04 PM »
Hi Zuxztah,
just noticed that the screen shot shows my custom DRO at the lower right hand corner. Note it reads 18000, my commanded or target spindle
speed but the TrueSpindle DRO above and slightly to the left of it shows zero. This IS as anticipated, the spindle is not running...
Also note that I set range 0 to have a min speed of 6000 rpm. My spindle is air cooled and it gets hot if you try to run it slow.
Craig
just noticed that the screen shot shows my custom DRO at the lower right hand corner. Note it reads 18000, my commanded or target spindle
speed but the TrueSpindle DRO above and slightly to the left of it shows zero. This IS as anticipated, the spindle is not running...
Also note that I set range 0 to have a min speed of 6000 rpm. My spindle is air cooled and it gets hot if you try to run it slow.
Craig