12111
General Mach Discussion / Re: re: Mach and it's conversion from inch to MM
« on: March 22, 2011, 07:53:40 PM »
Make sure there is a G20 at the start of the code you were sent and it should run fine.
Not sure what you are meaning by the Unit setting but if it is the native units then I would advise against doing that. Reason being you would then have to reset your steps per unit, your velocity and your acceleration to imperial units.
Hood
Not sure what you are meaning by the Unit setting but if it is the native units then I would advise against doing that. Reason being you would then have to reset your steps per unit, your velocity and your acceleration to imperial units.
Hood