14091
SmoothStepper USB / Re: spindle & Smoothstepper question
« on: November 12, 2010, 02:22:13 PM »
Although I have never set up a spindle other than a true Step/Dir spindle, your xml looks to be configured correctly.
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Although there is JHChoppers mill thread where he has a stepper that is connected to the spindle for indexing the ATC when i read how he'd done this I thought that would be a great why to run a C axis on a lathe, time will tell.
Sorry, my mistake.
I thought you were using that blue coloured ac motor with belt drive for your headstock (as shown in the earlier pictures).
Tweakie.
You use 24v too, don't you Hood?