6941
General Mach Discussion / Re: New KX3 not working
« on: June 06, 2017, 03:00:53 PM »
Hi,
it sounds like Mach3 is installed and is using the built in parallel port when powered up. You don't want to use PP you want
to use USB. At power up there should be a screen which allows you to choose your motion controller. It also allows you to
check a box so that it doesn't show up all the time.
'Function Cfg's/Reset Device Sel....' then close and restart Mach this time selecting the motion controller you are actually going to use!
Craig
it sounds like Mach3 is installed and is using the built in parallel port when powered up. You don't want to use PP you want
to use USB. At power up there should be a screen which allows you to choose your motion controller. It also allows you to
check a box so that it doesn't show up all the time.
'Function Cfg's/Reset Device Sel....' then close and restart Mach this time selecting the motion controller you are actually going to use!
Craig