So...
I confirm the machine is set for inches. Good there.
Then for kicks, I go and do a calibration again.
X & Y are good as before.
Z however moves the full range without stopping whereas before it either moved a slight amount or none at all. I stop the process as i do not have limit switches, yet!
I did not build this machine so I do not know the details. I am trying to establish the steps per inch for a starting point. The motors are 425 oz. in., 1.8*/200 steps per rev. (Automated Technologies inc. KL23H286-20-8B) How do I determine if this is set up with any microstepping, and if it is, how do I determine what the value is?
Doing a lot of reading and finding a lot of information, just not what I need (I think I need)
Thanks,
rockaukum