6971
General Mach Discussion / Re: Ballscrew mapping
« on: October 22, 2008, 05:38:03 PM »
Hmm........ ?
1?-So how you do use the pull down menu to enter hard data from a source other than feedback from an encoder?
2?-If a curve is created based on a known start point along the axis, and you are not using encoders, will it still work?
RICH
1?-So how you do use the pull down menu to enter hard data from a source other than feedback from an encoder?
2?-If a curve is created based on a known start point along the axis, and you are not using encoders, will it still work?
RICH