1
General Mach Discussion / Re: motors not turning
« on: December 13, 2013, 12:48:40 PM »
Problem is back last time I shut down the power strip and that caused the shut down
after I got it running again it run great even ran a couple programs
I had to shut power strip again now I can't get the motors to run
nothing was changed in setup just shut it down
if I don't turn power strip off no problems
I'm I messing .xml files and if so how do I get it straighten out?
after I got it running again it run great even ran a couple programs
I had to shut power strip again now I can't get the motors to run
nothing was changed in setup just shut it down
if I don't turn power strip off no problems
I'm I messing .xml files and if so how do I get it straighten out?