Hi,
So current I´m with the latest Mach4 SW release installed with an Hicon board 7766 running HiCON Plugin: 2.01.38, Board: 7766, Serial: 8BBC98, FW: 3.40, FPGA: 7E7B.
I had to reverse all back SW and FW to where I was. Everything is working again except the Go to Zero. When I click it, it gives me the message "" Axis 3 commanded while disabled""
Is this because of the new SW of the MACH4? It was the only thing that I haven´t downgrade. Any way, I hope you can help me figure this out.
Regarding the NEW Hicon SW/FW, ArcPro-Integra-Rev1.17 and Mach4-4092_Integra_Plugin_2.03.07. It just didn't work. Started with the issue above where the reference of all axes was not working, (MY MISTAKE, did not copy the M4HiCON. m4pw and .sig to the plugins folder.) Even after correcting this I was barred with other issues like:
* Go to Zero - does nothing.
* I've loaded a job, started the cut, the system executes the 1st G31 command (Torch hight position) M03 (plasma ON) does the cut but after at the end when it should switch off the plasma, go to a higher position and move the the next job, starting the all process again it doesn't, it ignores all the next commands
N0580 M05
N0590 G04 P2
N0600 G00 Z20.0000
N0610 X1385.6518 Y2345.4599
N0620 Z11.0000
N0630 G31 Z -100 F1200.0
N0640 G92 Z0.0
N0650 G00 Z0.0000
N0660 G92 Z0.0
N0670 G00 Z11.0000
N0680 M03
continuing with the cut, moving all around with the plasma on.
What am I missing here, what am I doing wrongly?