I've installed Mach 3 on quite a few computers but this problem is a first for me.
XP installed in Standard PC mode
Go through XP optimisation
Motherboard drivers installed
Install Mach3 and reboot
Run driver test - no line, and zero pulses per second, even though says system under Mach3 control
Tried ECC+EPP, and EPP settings for parallel port in the bios.
Uninstalled and re-installed Mach (including uninstalling pulsing engine from Device Manager) but same results.
I'm stumped, anyone got any ideas or should I toss the computer.
Processor is a 3Ghz P4, 2MB cache, 800 FSB and have 1G ram PC3200