Messages

291

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: April 15, 2016, 02:27:03 AM »

hernandd58 I have used V carve pro 8.024, using the mach3 ATC mm no problems at all

292

Mach4 General Discussion / Re: Upgrading from MACH3 to MACH4 with a DSPMC/ip V2

« on: April 10, 2016, 03:46:42 PM »

put it on a out rigger

293

Mach4 General Discussion / Re: MACH4, ESS, C25 smoth stepper terminal board V3.1, AND BL-TB6600-V1.2 problem

« on: April 10, 2016, 06:43:54 AM »

good stuff

294

Mach4 General Discussion / Re: MACH4, ESS, C25 smoth stepper terminal board V3.1, AND BL-TB6600-V1.2 problem

« on: April 10, 2016, 05:31:02 AM »

that's better Daz its something that surprised me, I did not think you put it correct, and the TB6600HG ic can be 50/50 depending on who made them, armature they may be Dead if the C25 enable does not get them going if the C25 only needs a enable, I will look at the manual my self

295

Mach4 General Discussion / Re: MACH4, ESS, C25 smoth stepper terminal board V3.1, AND BL-TB6600-V1.2 problem

« on: April 10, 2016, 04:20:16 AM »

Daz haveing a kill power on the stepper power can blow your stepper drivers it needs to be on the control enable disable.

also some BOBS need a Estop and a some stepper driver require a enable

all mine do

296

Mach4 General Discussion / Re: Upgrading from MACH3 to MACH4 with a DSPMC/ip V2

« on: April 10, 2016, 03:37:21 AM »

you are going at a good speed

297

Mach4 General Discussion / Re: MACH4, ESS, C25 smoth stepper terminal board V3.1, AND BL-TB6600-V1.2 problem

« on: April 09, 2016, 06:19:24 AM »

you need a E stop to start with ESS needs it

298

Mach4 General Discussion / Re: How many use Notepad++

« on: April 02, 2016, 06:07:40 PM »

yes, yes, yes if you don't have a back plotter or like to make changes to code notepad++ make's it easy.

299

PoKeys / Re: Pokey57CNC and Pendant

« on: March 19, 2016, 06:57:39 PM »

cherry very expensive  switch

300

PoKeys / Re: Pokey57CNC and Pendant

« on: March 19, 2016, 04:26:34 AM »

I ran into the same problem with hall effect limits on the 57CNC I had change to using switches, It's a nice board to use but with a couple of limitations