13701
General Mach Discussion / Re: Has anyone replaced an Anilam M control with Mach 3 ???
« on: December 15, 2010, 07:07:04 PM »
Its best to learn G Code but if you have CAD/CAM you can get by without it which will allow you to look at the code it produces and you will start picking it up as you go. Mach also has some wizards and might also be worth looking at the newfangled solutions addons. There is also LazyCAM which you can try, its basic but can do quite a bit. Think there may be a manual for LazyCAM in the members docs section of the forum.
Hood
Hood