Machsupport Forum

Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: dosuser on January 11, 2008, 08:19:13 PM

Title: AIO-400 Board
Post by: dosuser on January 11, 2008, 08:19:13 PM

Has anyone used this board with Mach3 software?
Could you give me setup information?
Unipolar Steppers.
I,m a newbie.

Title: Re: AIO-400 Board
Post by: Graham Waterworth on January 13, 2008, 06:34:10 AM

Mach should drive that board, problem is, it is very low power, 300mA is not much to drive a machine, a printer carriage maybe. Most machines need 2.0 to 3.0A minimum.

Graham.