5311
General Mach Discussion / Re: z zero plate problem
« on: February 10, 2018, 09:25:00 PM »
Hi,
not sure whats going on.
Incremental vs Absolute....have a look at G90 and G91
In Absolute
G0 X10 will cause the machine to drive from its current location to X=10
In Incremental
G0 X10 will cause the machine to drive its X axis another 10 units from its current location.
As I posted earlier all touch off routines have a G31 probing command. Can you open the button macro and post the code?
I really want to see what parameters have been put into the G31 command.
Craig
not sure whats going on.
Incremental vs Absolute....have a look at G90 and G91
In Absolute
G0 X10 will cause the machine to drive from its current location to X=10
In Incremental
G0 X10 will cause the machine to drive its X axis another 10 units from its current location.
As I posted earlier all touch off routines have a G31 probing command. Can you open the button macro and post the code?
I really want to see what parameters have been put into the G31 command.
Craig