Messages

21

General Mach Discussion / Re: Time to show off my ATC

« on: January 04, 2013, 07:13:31 PM »

how does the shot pin idea work ? thanks Mark Moog madness

22

General Mach Discussion / Re: Spindle parking (more moog madness )

« on: July 21, 2012, 08:20:00 PM »

hi steve no idea but an early one have been working on it for years . have taken heaps of scrap away ! mine is green . and a Q@C30 taper 25 turret tool changer ,now servoes all round .vfd drive no vari belt ( thank god) just looking intp the tool changer .its a bag of worms i can change it via switches just getting into how to automate it . Drawbar works on air using all the original bits but no oil

23

General Mach Discussion / Spindle parking (more moog madness )

« on: July 20, 2012, 07:06:45 PM »

Hi all I need some ideas for mu moog project . I need to park the spindle at a n exact rotational spot . Maybee adding another  optical index sensor and somehow hooking it to the VDF and doing a jog or something .I am fishing for ideas thanks mark

24

General Mach Discussion / Re: Digispeed not working

« on: April 12, 2012, 05:44:45 AM »

here is some more imformation hope this helps thanks again

25

General Mach Discussion / Re: Digispeed not working

« on: April 11, 2012, 08:08:15 PM »

is this what you need

26

General Mach Discussion / Re: Digispeed not working

« on: April 11, 2012, 06:36:07 PM »

sorry peter . what I have is the pins 1 through to 13 on the bob to pins 1 through to pins 13 on the db25 
 so pin 1 on the bob to pin 1 on the db25

    pin  2on the bob to pin2 onthe db25   etc etc
so bacisly I want the signals to pass through  If I just plug the two db25 plugs together without the bob in the middle the rutex works (but no digi speed ) if I put the bob in the middle the digi works . what I am trying to get to work is both . maybee I should give you a ring .thanks for your time

27

General Mach Discussion / Re: Digispeed not working

« on: April 05, 2012, 10:01:22 PM »

 Hi all sorry for the bad pictures  I have my workshop all packed up .I miss my computer with the things I want and use . I have the homman BOB and digi speed working well . I cant get the output to the rutex working . If I plug the two d25 cables together without the BOB it works fine (the Rutex bit ) I cannot get them to both work together . this is how I have them wired thanks Mark

28

General Mach Discussion / Re: Digispeed not working

« on: April 05, 2012, 08:33:36 AM »

 I will try . it will keep me busy for a while . 

29

General Mach Discussion / Re: Digispeed not working

« on: April 05, 2012, 05:10:33 AM »

Here it is I think and hope ! her is my set up the top plug goes to my Rurex 990 boards the bottom from the confuser

30

General Mach Discussion / any easy way to post pictures

« on: April 05, 2012, 12:53:02 AM »

 Hi all I am trying to post some pictures . Is there an easy way to do it ,.